Panasonic VDRD250EP - Instrukcja (Strona 25)

Se
tup
Power supply
25
LSQT1019
Setup
Power supply
When this unit is purchased, the battery is not charged. Charge the battery before using this unit.
≥ If the DC cable is connected to the AC adaptor, then the battery will not charge. Remove
the DC cable from the AC adaptor.
1 Connect the AC cable to the AC adaptor and the
AC outlet.
2 Put the battery on the battery mount by aligning
the mark, and then securely plug it in.
≥ The output plug of the AC cable is not completely connected to the
AC adaptor socket. As shown in A, there is a gap.
∫ Charging lamp
Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged (discharged excessively). In a while, the lamp will light up
and normal charging will start.
When the battery temperature is excessively high or low, the CHARGE lamp flashes and
the charging time will be longer than normal.
Charging the battery
≥ Battery charging time ( l 27)
≥ We recommend using Panasonic batteries.
≥ If you use other batteries, we cannot guarantee the
quality of this product.
A
LSQT1019(ENG).book 25 ページ ２００６年２月３日 金曜日 午後４時３７分