Panasonic VDRD250EP - Instrukcja (Strona 151)

Troubleshooting
Othe
rs
151
LSQT1019
Problem Check points
The screen has changed
suddenly.
≥ Has the demonstration started?
# If you set [DEMO MODE] to [ON] without inserting a disc or a
card in disc recording mode or card recording mode, the unit
is automatically set to the demonstration mode for
introducing its functions. Normally this should be set to
[OFF]. Press the MENU button, then select [SETUP]
#
[DEMO MODE] # [OFF] and press the joystick.
The remote control does
not function. ≥ Has the button-type battery of the remote control run out?
# Replace it with a new button-type battery. (l 18)
The DISC EJECT lever
does not work.
≥ The disc cover will not open unless the unit is powered.
# Connect a charged battery or AC adaptor.
≥ The DISC EJECT lever does not work when the unit is
connected to the computer. (l 155)
The disc cannot be read.
≥ Are there fingerprints or dirt on the surface of the disc?
# If there are fingerprints or dirt on the disc, wipe them off.
(l 24)
A function indication
such as remaining time
indication or elapsed
time indication is not
shown.
≥ If you set [SETUP] >[DISPLAY]>[OFF], indications other
than warnings and date indications disappear.
Recording does not start
although power is
supplied to this unit and
the disc or card is
correctly inserted.
≥ Is the DVD-RAM or the DVD-RW (VR format) write-
protected?
# Release the protection. (l 108) If the DVD-RAM or DVD-
RW (VR format) was protected on another device, release
the protection on the same device.
≥ Has the DVD-RW (Video format) or DVD-R been finalized?
# After finalizing, the discs become play-only and cannot
record. If you un-finalize a DVD-RW (Video format), it can be
used for recording. (l 107)
≥ Has the SD card’s write protect switch been set to LOCK?
# No recording is possible while the write protect switch is set
to LOCK. (l 23)
≥ Is the memory of the disc or card full?
# If the disc or card has no more available memory, free up
some memory by deleting unnecessary scenes (l 87, 100)
or use a new disc or card.
≥ Is the unit set to the disc recording mode or card recording
mode?
# No recording is possible unless the mode dial is at
or
.
≥ Is the disc cover open?
# If the cover is open, this unit may not operate normally. Close
the disc cover.
LSQT1019(ENG).book 151 ページ ２００６年２月３日 金曜日 午後４時３７分