Panasonic VDRD250EP - Instrukcja (Strona 117)

W
ith othe
r prod
uc
ts
With a printer (PictBridge)
117
LSQT1019
8 Select the layout setting on [ PAGE LAYOUT].
≥ You cannot set page layouts not supported on the printer.
9 Select [ PRINT] # [YES] and press the joystick.
The pictures are printed.
≥ Exit PictBridge by disconnecting the USB cable after the pictures
have been printed.
When you stop printing halfway
Move the joystick down.
A confirmation message appears. If [YES] is selected, the number of prints set is cancelled and the
screen returns to step 3. If [NO] is selected, all the settings are kept and the screen returns to
step 3.
STANDARD: Layout specific to the printer
: No frame print
: Frame print
≥ Avoid the following operations during printing.
These operations disable proper printing.
– Disconnecting the USB cable
– Removing the SD card
– Switching the mode dial
– Turning off the power
≥ Check the settings for the paper size, quality of
print, etc. on the printer.
≥ The sides of pictures recorded when [ ]
(VDR-D300)/[ ] (VDR-D250) is set may be cut
at printing. Check before printing.
When using the printer with a trimming feature or
other feature which cuts out both edges of the
pictures, cancel the feature for printing. (Refer to the
operating instructions of the printer for details.)
≥ You may not be able to print still pictures recorded
with other products.
≥ When the unit is connected directly to the printer,
the DPOF settings cannot be used.
≥ Connect the printer directly to this unit. Do not use a
USB hub.
2 2
1.7 1.7
LSQT1019(ENG).book 117 ページ ２００６年２月３日 金曜日 午後４時３７分