Orion 32LBT906D Instrukcja Obsługi

Strona 53

Advertising

English - 52 -

Analogue Manual Search

After selecting search type as analogue, you can use
“ ”/“ ” button to highlight an item and then press “
” or “ ” button to set an option.
Enter the channel number or frequency using the
numeric buttons. You can then press OK button
to search. When the channel is located, any new
channels that are not on the list will be stored.

Analogue Fine Tune

• Select Analogue Fine Tune from the Installation

menu by using “ ” or “ ” and OK buttons. Analogue
fi ne tune screen will be displayed. Analogue Fine
Tune feature will not be available if there are no
analog channels, digital channels and external
sources stored.

• Press OK button to proceed. Use “ ” or “ ” button

to set Fine Tune. When fi nished, press OK button
again.

Network Channel Scan

Select Network Channel Scan from the installation
menu by using “ ” or “ ” and OK buttons. Network
Channel Scan selection screen will be displayed.
Select Digital Aerial or Digital Cable and press
OK button to continue. The following message will
be asked. Select Yes to continue or select No to
cancel.

If you start Digital Aerial scan process, automatic
scanning will start. You can press “MENU” button
to cancel.
If you start Digital Cable scan process, the following
screen will be displayed.

You can select frequency ranges from this screen. For
highlighting lines you see, use “ ” or “ ” button. You
can enter the frequency range manually by using the
numeric buttons on the remote control. Set Start and
Stop Frequency as desired by using numeric buttons
on the remote control. After this operation, you can
set Search Step as 8000 KHz or 1000 KHz. If you
select 1000 KHz, the Tv will perform search process
in a detailed way. Searching duration will thus increase
accordingly. Depending on your Country selection in the
fi rst time installation, 250KHz search step option might
be available on Network Channel Scan screen. Note that
if you perform the search with 250KHz option, search
process could take a longer time.
Additionally, for some countries, Network ID option
will be available. Network ID feature gets the Network
Information Table. This table provides information on
the selected network. It may change according to the
operator and the region where that operator actively
broadcasts.
When fi nished, press OK button to start automatic
search. Automatic searching screen will be displayed
during the process.
Note: If you select an extended gap between Start
and Stop frequency rate, automatic search duration
will take a longer time.

Clear Service List (*)

(*) This setting is visible only when the Country option
is set to Denmark, Sweden, Norway or Finland.
Use this setting to clear channels stored. Press “
” or “ ” button to select Clear Service List and then
press OK. The following OSD will be displayed on
the screen:

Select YES and press OK to continue or select NO
and press OK button to cancel.

02_MB62_[GB]_woypbpr_IDTV_TC_NICKEL17_5110UK_32906W_10081597_50231723.indd 52

28.09.2012 13:21:42

Advertising