Orion 32LBT906D - Instrukcja (Strona 48)

English - 47 -
Connecting to a DVD Player
If you want to connect a DVD player to your LCD
TV, you can use connectors of the TV set. DVD
players may have different connectors. Please refer
to your DVD player’s instruction book for additional
information. Power off both the TV and the device
before making any connections.
Note: Cables shown in the illustration are not
supplied.
• If your DVD player has an HDMI socket, you can
connect via HDMI. When you connect to DVD player
as illustrated below, switch to HDMI source. See,
“Input Selection” section.
• Most DVD players are connected through
COMPONENT SOCKETS. Use a component video
cable to connect video input. For enabling audio,
use a component audio cable as illustrated below.
When the connection is made, switch to YPbPr
source. See, “Input selection” section.
• You may also connect through the SCART. Use a
SCART cable as shown below.
Note: These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.
Video Connection
HDMI
inputs
Scart socket
DVD player
YPbPr to PC
cable (optional)
Remote Control Handset
Inserting Batteries
• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the batteries from the remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
Switching On/Off
To Switch the TV On
• Connect the power cord to the 220-240V AC 50 Hz.
Then the standby LED lights up (The LED will blink
during the standby On/Off).
• To switch the TV on from standby mode either:
• Press the “ ” button, P+ or P- or a numeric button
on the remote control.
• Press the “ ” button, P/CH - or P/CH + button on
the TV. The TV will then switch on.
Note: If you switch on your TV via P+ or P- buttons on
the remote control or on the TV set, the programme
that you were watching last will be reselected.
To Switch the TV Off
• Press the “ ” button on the remote control or press
the “ ” switch on the TV, so the TV will switch to
standby mode.
• To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, the
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
02_MB62_[GB]_woypbpr_IDTV_TC_NICKEL17_5110UK_32906W_10081597_50231723.indd 47 02_MB62_[GB]_woypbpr_IDTV_TC_NICKEL17_5110UK_32906W_10081597_50231723.indd 47 28.09.2012 13:21:39 28.09.2012 13:21:39