Hoefer HB1000 - Instrukcja (Strona 13)

Note: Always use an even
number of bottles and load
bottles at opposite points to
balance the wheels of the bottle
holder carousel. This prevents
excessive wear of the bearings
and drive motor.
Set-up instructions
Two different bottle sizes are available for use in
the hybridization oven. The bottle holder carousel
can hold up to twenty (20) 35 × 150 mm bottles
or ten (10) 35 × 300 mm bottles. In addition,
combinations of both size bottles may be used at
the same time.
• To install the bottle holder carousel (Fig 1), slide
the bottle wheels (2) onto the rod and tighten the
thumb screws. Insert the rod into the holder on the
right wall. Slide the rod into the holder on the left
wall of the chamber.
• To adjust for various bottle lengths (Fig 2), loosen
the thumb screws on the bottle wheels and reposi-
tion them along the rod to accommodate the desired
bottle length.
• If skewed bottle positioning is required, loosen
the thumb screw on only one bottle wheel (Fig 2).
Slightly rotate the wheel until the required angle is
obtained. Retighten the thumb screw.
• To insert bottles into bottle clips, gently push bottle
into the clips (Fig 3).
•
p4
Fig 1. Installing bottle holder
carousel.
wheels rod
Fig 3. Inserting bottles.
Fig 2. Adjusting for various
bottle lengths.
thumb screw