Panasonic NVGS75EP Instrukcja Obsługi

Strona 48

Advertising
background image

Others

48

VQT0P93

access lamp is on may destroy the data on the
card.)

6: The cassette cannot be removed.
• Does the power lamp comes on when opening

the cassette cover? (

-11-

) Make sure that the

battery and the AC adaptor are properly
connected. (

-8-

)

• Is the battery in use discharged? Charge the

battery and remove the cassette.

• Close the cassette cover completely, and fully

open it again. (

-10-

)

7: No operation other than cassette removal

can be performed.

• Has condensation occurred? Wait until the

condensation indication disappears. (

-50-

)

8: The remote control does not function.
• Has the button-type battery of the remote

control run out? Replace it with a new button-
type battery. (

-16-

)

• Is the setting on the remote control correct? If

the setting on the remote control is not in
agreement with the [REMOTE] setting on the
movie camera, the remote control does not
operate. (

-17-

)

Recording
1: Recording does not start although power is

supplied to the movie camera and the
cassette is correctly inserted.

• Is the accidental erasure prevention slider on

the cassette open? If it is open (set to [SAVE]),
recording cannot be performed. (

-10-

)

• Is the tape wound to the end? Insert a new

cassette.

• Is the recording mode set? When in the

playback mode, recording cannot be
performed. (

-18-

)

• Has condensation occurred? No operation

other than cassette removal can be performed
when condensation occurs. Wait until the
condensation indication disappears. (

-50-

)

• Is the cassette cover open? If the cover is

open, the movie camera may not operate
normally. Close the cassette cover. (

-10-

)

2: The screen has changed suddenly.
• Has the demonstration started? In the Tape

Recording mode, if you set [DEMO MODE] >>
[ON] without inserting a cassette and a card,
the demonstration starts. For normal use, set
this function to [OFF]. (

-43-

)

3: A cassette cannot be inserted.
• Has condensation occurred? Wait until the

condensation indication disappears.

4: Auto focus function does not work.
• Is manual focus mode selected? If auto focus

mode is selected, focus is automatically
adjusted.

• There are some recording subjects and

surroundings for which the auto focus does not
operate correctly. (

-54-

) If so, use the manual

focus mode to adjust the focus. (

-29-

)

• Is the colour night view function set? When the

colour night view function is working, focusing
shifts into the manual mode.

Indications
1: A sentence is displayed in red or yellow in

the screen centre.

• Read the contents and respond to them.

(

-45-

)

2: The time code becomes inaccurate.
0 The time code indication counter may not be

constant in the reversed slow-motion playback,
but this is not a malfunction.

3: The remaining tape time indication

disappears.

• The remaining tape time indication may

disappear temporarily during frame-by-frame
playback or other operation. If you continue
ordinary recording or playback, the indication is
restored.

4: The remaining tape time Indication does not

match the actual remaining tape time.

• If scenes of less than 15 seconds are

continuously recorded, the remaining tape time
cannot be correctly displayed.

• In some cases, the remaining tape time

indication may show remaining tape time that is
2 to 3 minutes shorter than the actual
remaining tape time.

5: A function indication such as mode

indication, remaining tape time indication,
or time code indication is not shown.

• If you set [SETUP] >> [DISPLAY] >> [OFF],

indications other than the tape running
condition, warning, and date indications
disappear.

Playback (Sound)
1: Sound is not played back from the built-in

speaker of the movie camera or the
headphones.

0 Is the volume too low? During playback, push

the [

s

/VOL

r] lever to display the volume

indication and adjust it. (

-31-

)

2: Different sounds are reproduced at the

same time.

• Have you set [SETUP] >> [12bit AUDIO] >>

[MIX]? If you set [AUDIO REC] >> [12bit] and
dub audio to a recorded tape, you can hear the
sound on recording and the sound dubbed at a

GS75EP.book 48 ページ 2004年12月17日 金曜日 午前10時42分

Advertising