Before requesting repair (problems and solutions) – Panasonic NVGS75EP Instrukcja Obsługi

Strona 47

Advertising
background image

Others

47

VQT0P93

Before requesting repair (Problems
and solutions)

Power/Body
1: The movie camera power cannot be turned

on.

• Is the battery fully charged? Use a fully

charged battery.

• The battery protection circuit may have

operated. Attach the battery to the AC adaptor
for 5 to 10 seconds. If the movie camera still
cannot be used, the battery is faulty.

2: The movie camera power is turned off

automatically.

• If you set [POWER SAVE] to [5 MINUTES] and

do not operate the movie camera for about
5 continuous minutes, the power is
automatically turned off for tape protection and
power conservation. To resume recording, turn
the [OFF/ON] switch to [OFF]. Then turn it to
[ON] again. (

-42-

)

3: The movie camera power does not stay on

long enough.

• Is the battery low? If the remaining battery

power indication is flashing or the message
“LOW BATTERY” is displayed, the battery has
run down. Charge the battery or attach a fully
charged battery. (

-8-

)

• Has condensation occurred? When you carry

the movie camera from a cold place into a
warm place, condensation may occur inside it.
If so, the power is turned off automatically,
disabling all operations except for taking
cassettes out. Wait until the condensation
indication disappears. (

-50-

)

4: Battery runs down quickly.
• Is the battery fully charged? Charge it with the

AC adaptor. (

-8-

)

• Are you using the battery in an extremely cold

place? The battery is affected by ambient
temperature. In cold places, the operating time
of the battery becomes shorter.

• Has the battery worn out? The battery has a

limited life. If the operating time is still too short
even after the battery is fully charged,
depending on the usage, the battery has worn
out and can no longer be used.

5: The movie camera cannot be operated

though powered up.
The movie camera does not operate
normally.

• Remove the cassette and then press the

[RESET] button. (

-49-

) If normal conditions are

not restored yet, turn off the power. Then,
about 1 minute later, turn on the power again.
(Conducting the above operation when the

≥Scene mode

≥When setting the [AUTO/

MANUAL/FOCUS] switch
to [AUTO]

≥When the colour night

view function is used

≥Change of

white balance

≥When digital zoom

(10

k or higher)

is used

≥When the colour night

view function is used

≥When a menu is

displayed

≥Adjusting the

shutter speed,
iris/gain

≥When the colour night

view function is used

≥When the scene mode is

used

≥Variable-speed

search

≥During repeat playback

≥Deleting files

≥When the write protect

switch on the card is set
to [LOCK]

≥When the file is protected

≥Formatting

≥When the write protect

switch on the card is set
to [LOCK]

≥Audio dubbing

≥The section of a tape

recorded in LP mode

≥The blank section of a

tape

GS75EP.book 47 ページ 2004年12月17日 金曜日 午前10時42分

Advertising