Sony KDL-40ZX1 - Instrukcja (Strona 36)

36 GB
See the “Monitor Set-up” setting for monitor (page 46).
HDMI Set-up This is used to set the “Control for HDMI” compatible equipment connected to the
HDMI sockets. Note that the interlock setting must also be made on the connected
“Control for HDMI” compatible equipment side.
Control for HDMI This sets whether to interlock the “Control for HDMI”
compatible equipment and the unit. When set to “On”, the
following menu items can be performed. However, power
consumption in standby mode is higher than usual. If the
specific Sony equipment that is compatible with “Control for
HDMI” is connected, this setting is applied to the connected
equipment automatically when the “Control for HDMI” is set
to “On” using the unit.
Auto Devices Off When this is set to “On”, the “Control for HDMI” compatible
equipment turns off when you switch the unit to standby
mode using the remote.
Auto TV On When this is set to “On” and if the connected HDMI control
compatible equipment is turned on, the unit automatically
turns on, and the displays the HDMI input from the
connected equipment.
Device List
Update Creates or updates the “HDMI Device List”. Up to 14
“Control for HDMI” compatible equipment can be
connected, and up to four equipment can be connected to a
single socket. Be sure to update the “HDMI Device List”
when you change the “Control for HDMI” compatible
equipment connections or settings. Select them manually one
by one until getting a correct picture for several seconds.
HDMI Device List Displays the connected “Control for HDMI” compatible
equipment.
Product Information Displays your media receiver’s product information.
Select “Monitor Product Information” to display your monitor’s product
information.
All Reset Resets all settings to the factory settings and then displays the “Auto Start-up”
screen.
z
• Be sure not to turn the unit off during this period (it takes about 30 seconds) or
press any buttons.
• All settings, including digital favourite list, country, language, auto tuned
channels, etc. will be reset.
Monitor Set-up
Analogue Set-up
Programme List
Display Select “Off” to hide the list of analogue channels from the XMB™
(XrossMediaBar).
Auto Tuning Tunes in all the available analogue channels.
This option allows you to retune the unit after moving house, or to search for new
channels that have been launched by broadcasters.