Samsung DSB-H370 - Instrukcja (Strona 41)

GB-31
DSB-H370G
GB
OPERATING THE RECEIVER
GB-30 D I G I T A L S A T E L L I T E R E C E I V E R
DSB-H370G
OPERATING THE RECEIVER
5. Embedded Nagravision
● Nagravision Information is used for displaying information
about card (card status, card number etc.)
6. Manual Software Upgrade
You can download and upgrade the software of this STB
through ASTRA, Hotbird or Sirius satellite when the
new software is released.
N No otte e : These satellites for upgrading software on Samsung
Brand can be changed in the future.
During downloading don’t turn off the STB.
If there is a new version of software to download, you are
asked whether you want to do update or not.
If you press OK key, the update starts right away.
In case update is impossible, you get this message “You can’t update software!”
Or in case you don’t need to update, “You don’t need to update software!” will be displayed.
If you get information that a Transponder is changed to different one for Samsung software, you
should select ‘User Advanced Mode’ at Menu mode by using the
¦/‹¤key.
Then you should set exact parameters for the new transponder for Samsung.
7. Messages
Message is used for reading, viewing and removing
received short messages from the operator.
4. Parental Lock
This “Parental Lock” feature sets viewing restrictions and
prevents unauthorized access to your STB through the PIN
(Personal Identification Number), which is a 4 digit number.
(The factory preset PIN Code : 0000)
On selecting this menu, you will have two options:
to set lock for any desired channel and to change your PIN
value.
● Enter PIN Code.
If you have not entered your own PIN Code then the
PIN Code 0000 applies, which was set at the factory.
4.1 Set Channel Lock
● Select the channel by pressing œ/ƒ, CH /CH , ¦/‹ or
numeric keys.
● When you press the TV/RADIO key, TV list and Radio list are
toggled.
● Select the channel lock by pressing RED key.
● Press OK key for confirmation.
This will lock the channel. Whenever you need to view the
channel, you will have to enter the PIN at the request window.
After successfully entering PIN code on any locked channel,
you will not need to enter the PIN code once again on any other
locked channel, unless STB was turned off or in stand-by mode.
To cancel the lock :
● Press RED key again in order to cancel the lock.
4.2 Change PIN Code
To change the PIN Code, select the second option “Change
PIN Code”.
This will take you to the following menu:
In this option, you need to enter the current PIN Code at the first
cursor, and at the second cursor enter the desired PIN Code.
To confirm, you need to enter the new PIN Code again. Please
remember the PIN Code should be a 4 digit numerical value.
THE FACTORY PRESET PIN Code : 0 0 0 0.
N No otte e : If you forgot the PIN Code, contact to the SERVICE
PROVIDER. Once you change password, please do not
forget and keep well.
00431A_H370G_POL_EngV2 8/10/07 3:23 PM Page 30