Samsung DSB-H370 - Instrukcja (Strona 29)

Component Connection
1. Connect the coaxial cable from the LNB of
your antenna to “DISH INPUT” terminal
marked at the rear of the STB.
2. Connect the Video Cables. YPbPr format
Connect a Component video cable between
the VIDEO OUT jacks on the Set-Top Box and
the TV INPUT jacks on the TV.
3. Connect the Audio Cables. Connect an audio
cable between the L/R AUDIO OUT jacks on
the Set-Top Box and the L/R AUDIO IN jacks
on the TV.
Connecting the receiver with dish system
After installing your antenna system, connect
the coaxial cable from the LNB of your
antenna to “DISH INPUT” terminal marked at
the rear of the STB.
All cable connectors should be finger
tightened; do not use any kind of wrench while
tightening connectors. The cable should be
75ohm impedance coaxial twisted at the end
with an “F” type connector.
GB-7
DSB-H370G
GB
CONNECTING YOUR “STB” CONNECTING YOUR STB
GB-6 D I G I T A L S A T E L L I T E R E C E I V E R
DSB-H370G
Connecting the receiver with dish system
SCART Connection
1. Connect the coaxial cable from the LNB of
your antenna to “DISH INPUT” terminal
marked at the rear of the STB.
2. Connect a SCART cable between the VCR
OUT jacks on VCR and the Scart AV2
(EXT) jacks on the STB.
3, Connect Scart cable between AV1 (TV) jack
on the STB and jack Scart Input on the TV
Connecting the Set-Top Box to a TV Set
1. Connect the coaxial cable from the LNB of
your antenna to “DISH INPUT” terminal
marked at the rear of the STB.
2. Connect a HDMI cable between the HDMI OUT
jack on the Set-Top Box and the HDMI IN jack
on the HDMI device (TV , Monitor)
N No otte e : - Depend on the any receiver and cable,
HDMI out may not operate properly.
- Depend on the TV, sound not be output. In
this case, you can hear by connecting Audio
L/R Cable.
Connecting the Set-Top Box to a TV with a HDMI jack
There are many types of audio systems on the
market today.
A simplified illustration of an audio system is
shown to the right. For more information, see
your audio system owner’s manual.
For an optical digital audio input, connect the
audio system to the DIGITAL AUDIO (OPTICAL)
jack on the Set-Top Box.
Connecting an Audio Component
Audio Rear Panel
00431A_H370G_POL_EngV2 8/10/07 3:23 PM Page 6