Samsung DSB-H370 - Instrukcja (Strona 38)

3. System Setup
This option enables you to change the factory preset
system settings as per your requirements.
3.1 Language Selection
The “Language Selection” option allows the user to select the
desired language of the OSD, Primary Soundtrack, Secondary
soundtrack, EPG Primary Language, EPG Secondary Language.
However, these languages for Primary Soundtrack, Secondary
soundtrack, EPG Primary Language, EPG Secondary Language
depend on broadcasting.
For example, even 'English' for Primary Soundtrack can be
selected, it may not be supported when the channel doesn't
provide proper service.
● For user convenience, 7 different languages are available in
OSD menu.
● To select the desired language menu, press ¦/‹¤keys to
change language and press OK.
● The OSD Language, Primary Soundtrack, Secondary
soundtrack, EPG Primary Language, EPG Secondary
Language will vary according to the selected language.
GB-25
DSB-H370G
GB
OPERATING THE RECEIVER
GB-24 D I G I T A L S A T E L L I T E R E C E I V E R
DSB-H370G
OPERATING THE RECEIVER
2.5 Reset to Factory Defaults
This is to recover the Factory set values in case the user has
encountered some problems after changing any values of
channel data and others which may be in error.
The screen display will be as follows:
At the request window, if you press OK key, the receiver will be
reset to factory default settings automatically. Then First
Installation
Procedure will start. Press EXIT to cancel.
N No otte e : This cause your previous settings to be deleted!
All settings and information including channel data will
be deleted.
2.6 Home Transponder Sett.
This is to set new settings for Home Transponders which are
used for downloading network services list.
Input the Frequency, Poliarity, Symbol Rate and FEC using
¦/‹¤or numeric keys.
● Select Home Transponder you want to set.
You can select the value of 1, 2 or 3.
● Input the Frequency of the transponder you want to find.
● Input the Polarity of the transponder you want to find.
You can select the value of Horizontal, Vertical, Circular Left
or Circular Right.
● Input the Symbol Rate of the transponder you want to find.
● Press OK key to confirm your selection.
00431A_H370G_POL_EngV2 8/10/07 3:23 PM Page 24