Ivoclar Vivadent Bluephase v.1 - Instrukcja (Strona 8)

8
Start-Up
Check the delivery for completeness and any possible
transportation damage (see delivery form). If parts are
damaged or missing, contact your Ivoclar Vivadent
representative.
Charging base
Before you switch on the device, make sure that the
voltage mentioned on the rating plate complies with
your local power supply.
Slide the connection plug of the power pack into the
socket on the underside of the charging base. Tilt it
slightly and apply slight pressure until you hear and feel
it snap into place. Place the charging base on a suitable,
flat table top.
Heat development
As it is the case with all high-performance lights, the
high light intensity results in a certain heat development.
Prolonged exposure of areas near the pulp and soft tis-
sues may result in irreversible damage. Therefore, the
stipulated polymerization time, particularly in areas near
the pulp (adhesives: 10 seconds) must be observed.
Uninterrupted curing times of more than 20 seconds on
the same tooth surface, as well as direct contact with the
gingiva, oral mucous membrane or skin have to be pre-
vented. Polymerize indirect restorations at intermittent
intervals of 20 seconds each or use external cooling with
an air stream.