Panasonic NVGS140EP - Instrukcja (Strona 27)

Record mode
27
VQT0P88
Fade in/fade out function
Fade in
The image and audio gradually appear.
Fade out
The image and audio gradually disappear.
≥Set to Tape Recording Mode.
1 Press the joystick until the icon 1 appears.
2 Move the joystick left to select the fade icon
[
].
3 Press the recording start/stop button.
Start recording. (fade in)
When you start recording, the image/audio
disappeared completely and the image/audio
gradually appears.
Pause recording. (fade out)
The image/audio gradually disappears. After the
image/audio completely disappears, recording
stops.
ª To cancel fading
Select the [ ] icon again.
ª To select the colour for fade in/out
The colour which appears in fading pictures can
be selected.
1 Set [SETUP] >> [FADE COLOUR] >>
[WHITE] or [BLACK].
≥While the fade in/fade out function is selected, it
takes several seconds to display the image
when you start recording images. Besides, it
also takes several seconds to pause recording.
Wind noise reduction function
This reduces the wind noise coming into the
microphone when recording.
≥Set to Tape Recording Mode.
1 Set [BASIC] >> [WIND CUT] >> [ON].
ª To cancel the wind noise reduction
function
Set [BASIC] >> [WIND CUT] >> [OFF].
≥Reduces the wind noise depending on the wind
strength. (If this function is activated in strong
winds, the stereo effect may be reduced. When
the wind weakens, the stereo effect will be
restored.)
Using the built-in video flash
Use the built-in video flash in order to record still
pictures in dark places.
≥Set to Tape/Card Recording Mode.
1 Set [ADVANCE] >> [FLASH] >> [ ß] or [ßA].
≥If [ ßA] is selected, then the video flash will
automatically flash as necessary.
2 Press the [PHOTO SHOT] button.
≥The video flash is activated and the picture
will be recorded.
≥You cannot use the built-in video flash unless
the card is inserted in the movie camera.
≥The movie camera, even when its video flash
has been turned off, automatically determines if
the flash is necessary by detecting the ambient
brightness. (If it determines that the flash is
necessary, the [
] indication lights up in
yellow.)
≥When the [ ß] ([ßi]/[ßj]) indication or the [ßA]
([ ßAi]/[ßAj]) indication is displayed, the video
flash can be lit. If the indication is flashing or not
displayed, the flash cannot be lit.
≥The available range of the video flash is approx.
1 to 2.0 metres in a dark place. Pictures will
appear dark or reddish when they are recorded
by using the video flash at distances greater
than 2.0 metres.
1
B
PHOTO
SHOT
GS150_EP.book 27 ページ ２００４年１２月２２日 水曜日 午後２時６分