MPM 12-KPO-04 - Instrukcja (Strona 24)

2
GB
WATER DRAINGE METHODS
This product has a self-evaporative system. The condensing water will recycle to
cool the condenser. This water-cooled mode can not only improve cooling efficiency
and decrease noise, but also save energy for you.
* When in cooling mode, the water from the evaporator will flow into a inside pan. When the
water reaches the low level, the water pump will work until the water is under the low
level. When the water reaches the high level, the compressor will stop working, and the
water pump, lower fan motor and upper fan motor will work on all the time.
* When in heating mode, the water pump won't work.
* When the water is full, the water full indicator will light and the compressor will stop
working. The buzzer will buzz 10 times every 5 minutes until the water is below the high
level or drained by hand. When the alarm stops and after three-minutes restart delay, the
unit will work normally.
* Before you empty the unit you will need to
turn the unit off and pull the plug out of the power
supply.Upcap the lid, remove the rubber plug on the
drainage port, then let the water flow out.Once
drained, put the rubber plug back and screw the lid
up an switch it on. The compressor will delay
restarting for three minutes,then the unit will
work normally.
* Move the unit gently when the water is high. If
not , the water may spill from the inside of the unit .
* When the water in the cave is not enough for
pumping, the pump will stop working. At the same
time, the Water Injection indicator on the control
panel will illuminate ( ), you had better inject
some water into the water draw carefully. In order
to avoid the water flooding from the under pan, you should inject water no more than
1800ml (three cups). This operation helps save 20%-30% energy for you.
MAINTENANCE
Cleaning
Turn off the unit and pull the plug out of the socket before any cleaning.
1.Clean the surface
Clean the surface of the unit with a duster or a half-wet soft cloth.
Do not use chemical solvent like benzene, alcohol, gasoline and etc,
Or the surface may be damaged or even deformed.
2. Clean the air filter
If the air filter is blocked with a lot of dust, the
efficiency will reduce. You’d better clean the
filter every two weeks.
1)Pull out the air filter as Fig.14.
2)Wash the air filter by immersing it gently
into warm(under 40
°C or 104°F)water with
neutral detergent. Rinse the filter and dry it in
a shaded place.
3)Push the air filter back into the original
position.
End of season
1. Upcap the lid, remove the rubber plug on the drainage to drain the water.You can remove
the water entirely by slanting the unit back.
Setting the fan mode, then press the Fan button for 5 seconds until the lower fan works.
After that, operate the unit in fan mode for half a day until the pipe is dry. In this way the
inside of the unit can be dried and the mildew growth can be suppressed.
2.Switch off the unit and disconnect the plug from the power supply.
3.Tie the cable with sting.
4.Remove the air exhaust duct and keep it carefully.
5.Wrap the unit with the plastic bag, and keep it in a dry place.
6.Take the batteries out of the remote control and keep them well.
INSTR.indd...24 2011-01-10...11:11:19