Orion 26LBT981 - Instrukcja (Strona 8)

English - 7 -
LCD TV and Operating Buttons
Standby/On button
TV/AV button
Programme Up/Down buttons
Volume Up/Down buttons
Note: Press “ ” and “ ” buttons at the same time
to view main menu.
-or-
-or-
Up direction 1.
Down direction 2.
Programme/Volume / AV / 3.
Standby-On selection switch
Note: You can move the switch, upward
or downward to change the volume. If
you want to change channels, press the
middle of the switch once (Position 3) and then move upward
or downward. If you press the middle of the switch once more,
source OSD will be displayed. If you press the middle of the
switch and hold about a few seconds, the TV will switch to
standby mode. Main menu OSD cannot be displayed via
control buttons.
Step 1 - Checking the TV and Accessories
Note: You should check the accessories after purchasing. Make
sure that each accessory is included.
Step 2 - Installing the Batteries to the Remote
Lift the cover on the back of the remote upward gently. 1.
Install two AAA batteries. Make sure to match the + and - 2.
ends of the batteries in the battery compartment (observe
the correct polarity.
Replace the cover.
3.
Step 3 - Connect Power and Antenna/Cable
a. Antenna and Power Cable Connection(*)
(*) If your TV has a direct power cable, follow these
instructions:
insert plug...
REAR OF THE TV
or
Use 75 ohm round
antenna cable. You can
connect antenna or
satellite box antenna or
cable.
Make sure the power
plug is plugged securely
to the wall outlet.
b. Power Adapter Connection (*)
(*) Power Adapter connection (only for TV models with 12V
power adapter):
IMPORTANT: The TV set is designed to operate on 12 V DC. For
this, an adaptor is used which gives12 V voltage. Connect this
adaptor to a system that supplies 110-240V AC, 50/60Hz.
Step 5 - Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz. •
Press • button. Then the standby LED lights up.
To switch on the TV from standby mode either: •
Press the “ • ” button, P+ / P- or a numeric button on the remote
control.
Control buttons on the TV)
Press the • -P/CH or P/CH+ button on the TV. The TV will then
switch on.
-or-
Press the middle of the control switch right side of the TV. The •
TV will then switch on.
To Switch the TV Off
Press the “ • ” button on the remote control or press the
button or hold the control switch on the Tv until shut down, so
the TV will switch to standby mode. (Depends on model)
To power down the TV completely, unplug the power cord from
•
the mains socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search, Over
Air Download or Timer is active. The LED can also blink when
you switch on the TV from standby mode.
01_MB62_[GB]_woypbpr_IDTV_TC_NICKEL17_3902UK_26981W_10078517_50216677.indd 7 01_MB62_[GB]_woypbpr_IDTV_TC_NICKEL17_3902UK_26981W_10078517_50216677.indd 7 27.04.2012 18:04:51 27.04.2012 18:04:51