Programme recording (optional), Recording via epg screen(optional) – Orion 26LBT981 Instrukcja Obsługi
Strona 12
English - 11 -
Programme Recording (Optional)
To record a programme, you should fi rst connect a USB disk to
your TV while the TV is switched off. You should then switch on
the TV to enable recording feature.
IMPORTANT: When using a new USB hard disk drive, it is
recommended that you fi rst format the disk using your TV’s
“Format Disk” option.
For using recording function, you should connect a USB disk or
•
an external hard disk drive to the TV and connected USB disk
should have at least 1 GB capacity and should have 2.0 speed
compatibility. If the connected USB device does not support 2.0
speed, an error message will be displayed.
The Tv can record only FAT32 formated disks.
•
Note: It is possible that recorded broadcasts in. TS format may
not be supported by your media playback software. In such a
case, you should install an appropriate media playback software
to your computer.
An hour of the recordings stored occupies approximately 2
•
GB of space.
For more information on recording programmes, see sections
•
“Instant Recording”, “Timeshifting”, “Electronic Programme
Guide”, “Recordings Library” or “Recording Timers” in the
following parts.
Recorded programmes are split into 1GB (approximately an
•
hour) partitions. Names of the stored recordings’ last three digits
indicates this: Such as 4801-000.ts , 4801-001.ts.
If the writing speed of the connected USB disk is not suffi cient,
•
recording may fail and timeshifting feaute may not be
available.
Multipartiton support is available. Maximum two different
•
partitions are supported. If the disk have more than two
partitions, crash may occur. First partition of the usb disk is used
for PVR ready features. It also must be formatted as primary
partition to be used for PVR ready features.
Recordings of HD programmes can occupy bigger size on the
•
USB disk depending on the broadcast’s resolution. For this
reason it is recommended to use USB hard disk drives for
recording HD programmes.
Do not plug out the USB/HDD during the recording. This may
•
harm the connected USB/HDD.
Some stream packets may not be recorded because of signal
•
problems, so sometimes video may freezes during playback.
Record, Play, Pause, Display (for PlayListDialog) keys could
•
not be used when teletext is ON. If a recording starts from timer
when teletext is ON, teletext is automatically turned off. Also
teletext usage is disabled when there is ongoing recording or
playback.
Radio record is not supported.
•
The TV can record programmes up to ten hours.
•
Recording via EPG Screen(Optional)
IMPORTANT: To record a programme, you should fi rst connect
a USB disk to your TV while the TV is switched off. You should
then switch on the TV to enable recording feature. Otherwise,
recording feature will not be available.
(RECORD): The TV will start to record the selected
progamme. You can press again to stop the recording.
Note: Switching to a different broadcast or source is not available
during the recording.
/
: Page left / Page right.
Programme Options
In EPG menu, press the OK button to enter the “Event Options”
menu.
Select Channel
In EPG menu, using this option, you can switch to the selected
channel.
Record / Delete Record Timer
IMPORTANT: To record a programme, you should fi rst connect
a USB disk to your TV while the TV is switched off. You should
then switch on the TV to enable recording feature. Otherwise,
recording feature will not be available.
After you have selected a programme in EPG menu, press the
•
OK button and and Options screen will be displayed. Select
“Record” option and press the OK button. After this operation,
a recording becomes set to the selected programme.
To cancel an already set recording, highlight that programme
•
and press the OK button and select the option “Delete Rec.
Timer”. The recording will be cancelled.
Note: You cannot switch to any other channel or source while
there is an active recording on the current channel.
Set Timer / Delete Timer
After you have selected a programme in EPG menu, press the
OK button and and Options screen will be displayed. Select “Set
01_MB62_[GB]_woypbpr_IDTV_TC_NICKEL17_3902UK_26981W_10078517_50216677.indd 11
01_MB62_[GB]_woypbpr_IDTV_TC_NICKEL17_3902UK_26981W_10078517_50216677.indd 11
27.04.2012 18:04:53
27.04.2012 18:04:53