Hoefer UVC5000 - Instrukcja (Strona 16)

User set UV energy exposure
Sometimes it may be necessary for you to set
your own standards for exposure. This is easily
accomplished as follows:
1
Push ENERGY on the tactile touch pad then set your
energy exposure requirements by inputting the value
on the touch pad.
The energy exposure settings should now be displayed
on the LED in flashing mode.
Confirm that the setting is correct, then push ENTER
on the touch pad.
2
Push START on the touch pad. After a slight delay to
energize the UV tubes, the LED will begin to count
down. The unit will automatically stop at the end of
the exposure cycle and will beep five times.
Exposure is now complete.
•
p7
Note: The actual exposure
will be 100 times your
displayed setting.