Panasonic NVGS320 - Instrukcja (Strona 64)

Menu
64
VQT1A45
Menus related to taking pictures
ª [DATE/TIME]
This switches between date and time indications.
≥The movie camera automatically records the
date and time of picture taking on the tape/card.
≥You can also show or change the date/time
indication by repeatedly pressing the
[DATE/TIME] button on the remote control.
ª [AUDIO REC]
Switches the audio (PCM audio) recording
systems.
[12bit]: Records audio in “12 bit 32 kHz 4 tracks”.
(The original audio signals can be kept
after the other audio signals are dubbed.)
[16bit]: Records audio in “16 bit 48 kHz 2 tracks”.
Audio can be recorded in higher quality.
(If audio signals are dubbed, then the
original audio signals will be erased.)
ª [DISPLAY]
Set to [ON] and the display mode can be switched
to all functions. Set to [OFF] and it can be
switched to minimum display.
ª [BEEP SOUND]
Set to [ON] and confirmation/alarm beeps are
issued as follows.
1 Beep
≥When you start recording
≥When you turn on the power
≥
When the unit goes from quick start standby
mode to recording pause
2 Beeps
≥When you pause recording
≥When you turn off the power
≥When the unit goes into quick start standby mode
2 Beeps for 4 times
≥When a cassette with its erasure prevention tab
set to [SAVE] is inserted, condensation occurs
(
-73- ), and at other times. Check the sentence
displayed on the screen. ( -67- )
ª [POWER SAVE]
[OFF]: When about 5 minutes passed
without any operation, the standby
mode automatically will be set. In
the standby mode, [
;] blinks and it
takes time more than usual to start
recording after you press the
recording start/stop button.
[5 MINUTES]:When about 5 minutes passed
without any operation, the movie
camera automatically turns off to
protect the tape or to prevent the
battery from running down. When
you use the movie camera, turn it
on again.
≥In the following cases, the power may not turn
off even when set [POWER SAVE] >>
[5 MINUTES].
≥When connecting to the AC outlet
(When using the AC adaptor)
≥When connecting the USB cable or the DV
cable to a personal computer or other
equipment
≥When in PC Connection Mode
Menus related to playback
ª [REC DATA]
Set to [ON] and the settings (shutter speed, iris/
gain values, and white balance settings (
-37- ),
etc.) used during the recordings are displayed
during playback.
≥If the [AUTO/MANUAL/FOCUS] switch was set
to [AUTO] when recording, [AUTO] appears on
the display.
≥When there is no data, [---] appears on the display.
≥If data recorded on this unit is played back on
other equipment (or a tape recorded on other
equipment is played back on this unit), the
settings information is sometimes not displayed
normally.
ª [AUDIO OUT]
This switches the sound to be played back.
[STEREO]: Stereo sound (main sound and sub
sound)
[L]: Left channel sound (main sound)
[R]: Right channel sound (sub sound)
VQT1A45_EP_ENG.book 64 ページ ２００６年１２月６日 水曜日 午前９時１０分