Orion TV40FBT912 - Instrukcja (Strona 28)

English - 27 -
Installing the Batteries to the Remote
1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
1
Aerial or Cable
227330
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz.
Press “ ” button. Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the “ ” button,
P+ or P- or a numeric button on
the remote control.
To Switch the TV Off
Press the “ ” button on the remote control or press
the “ ” button on the TV or press and hold the control
switch on the TV until shut down, so the TV will switch
to standby mode(depends model).
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search,
Over Air Download or Timer is active. The LED can also blink
when you switch on the TV from standby mode.
First Time Installation
When turned on for the first time, the “language
selection” menu appears. The message “ Welcome
please select your language!” is displayed in all
language options listed alphabetically.
Press the “ ” or “ ” button to highlight the required
language, press OK button to select. “First Time Installation”
appears. Use “ ”or “ ” button to set the required country, and
press “
” button to select Search Type. Use “ ”or “ ” to
set the desired search type. Available search types are Digital
and analog, digital only and analog only. When set, press “
” to select Teletext Language. Use “ ”or “ ” button to set
the “Teletext Language” and select “Scan Encrypted” using “
” or “ ” button. You can set Scan Encrypted as Yes if
you want to scan coded stations.
Press OK button on the remote control to continue and
the following message will be displayed on the screen.
You can activate Store mode option by using “ ” or
“ ” button. If Store Mode is selected, Store mode
option will be available in other settings menu and your
TV’s settings will be optimized for best display quality.
A confirmation screen will be displayed after selecting
the Store Mode. Select YES to proceed.