Crivit MS-1348 - Instrukcja (Strona 5)

5
• RISK oF InjURy!
Risk of injury and accidents! test the fishing rod for damage each time before use. never use a
damaged fishing rod; if you do, it may not function properly and may, as a result, not be safe.
Risk of injury and accidents! this product contains sharp hooks which can cause considerable
injury to the user or other persons. therefore use the fishing rod with due caution.
• pay due regard to other anglers (and any other people) and keep a safe distance. some risk of
injury exists from the hook snapping back/sideways in an unpredictable direction when casting
the line if this is not done properly.
• to prevent hook injuries, wear the appropriate glasses and protective headgear.
• do not carry out repairs yourself. Consult the service department.
• Keep the fishing rod out of reach of children.
• only allow children to use the fishing rod under the instruction and supervision of an adult.
Use
Before Using...
Caution: Before fishing, enquire about national laws and local regulations. these instructions give
the general directions for using the product. the sport of angling is well-developed, with many
aspects. We therefore recommend reading appropriate specialized literature and / or seeking advice
from clubs and associations.
How To Assemble The Rod
1. insert the reel (4) into the reel supports (2). Fasten it by turning the fixing screw (1) clockwise.
2. in order to put the winder (6) in the desired position, loosen the screw opposite (5) by turning it
anti-clockwise and when the winder is positioned appropriately, tighten the screw again.
3. Release the line reel brake (7) by turning it anti-clockwise. pull the fishing line (11) out of the reel
(4) and pass it under the line guard (3) through all rings on the rod. tighten the line reel brake (7)
again by turning it clockwise.
4. unwind the ground fishing system (9) carefully from the winding board and lay it out flat.
5. Make a loop in the end of the fishing line (11). For this, double the fishing line (11) and wind it
through the loop several times, finally pulling it tight (see diagram B). hook the carabiner (10)
from the ground fishing system (9) onto the fishing line (11). ensure that the carabiner (10) is
closed again after hooking it on.
6. pull the rod out segment by segment, beginning at the tip as in diagram C. never cast the rod to
pull out the segments.
Casting the rod
• Activate the rewind stop (8) and tilt the line guard (3) forwards so that the fishing line (11) can
unreel freely.
• Cast the rod. turn the winder (6) a little – the line guard (3) automatically clicks into position.