Samsung DSB-S305 - Instrukcja (Strona 34)

GB-27
DSB-S305G
GB
GB-26 D I G I T A L S A T E L L I T E R E C E I V E R
DSB-S305G
OPERATING THE RECEIVER
4.2 Change PIN Code
To change the PIN Code, select the second option “Change
PIN Code”.
This will take you to the following menu:
In this option, you need to enter the current PIN Code at
the first cursor, and at the second cursor enter the desired
PIN Code.
To confirm, you need to enter the new PIN Code again.
Please remember the PIN Code should be a 4 digit numerical value.
THE FACTORY PRESET PIN Code : 0 0 0 0.
N No otte e : If you forgot the PIN Code, contact to the SERVICE PROVIDER.
Once you change password, please do not forget and keep well.
5. Embedded Nagravision
● Nagravision Information is used for displaying information
about card (card status, card number etc.)
● Mail Message is used for reading, viewing and removing
received short messages from the operator.
6. Manual Software Upgrade
You can download and upgrade the software of this STB
through ASTRA, Hotbird, Sirius or Eutelsat satellite when the
new software is released.
N No otte e : These satellites for upgrading software on Samsung
Brand can be changed in the future.
During downloading don’t turn off the STB.
If there is a new version of software to download, you are
asked whether you want to do update or not.
If you press OK key, the update starts right away.
In case update is impossible, you get this message “You can’t update software!”
Or in case you don’t need to update, “You don’t need to update software!” will be displayed.
If you get information that a Transponder is changed to different one for Samsung software,
you should select ‘User Advanced Mode’ at Menu mode by using the
ᮤ / ᮣ key.
Then you should set exact parameters for the new transponder for Samsung.
Problem Possible cause Solution of the problem
No display LED on Power cord Power cord plug in correctly
the front panel; not plugged in correctly
No power supply
No pictures on the screen Receiver in Standby mode; Set receiver to “On”;
Scart not connected tightly Check connection and correct;
to video output of television;
incorrect channel or video
Check channel and video output and
output selected on television correct (TV instruction manual)
No sound Audio cord connected Check connection and correct;
incorrectly;
Loudness level = 0;
Increase loudness on television set;
Muting active Press the MUTE key
Remote Control does not incorrect operation; Point remote control
operate directly towards the Receiver.
Batteries dead or inserted Replace batteries or insert correctly
incorrectly
Poor picture quality Signal strength to low Check all wire connections. Check the
signal strength in “LNB Setting” menu, correct
alignment of your antenna
On-Screen Error Message Antenna cable not connected Check connection and correct;
“Searching for signal” or not tight;
LNB defective;
Change LNB;
incorrect position of the Check position and correct;
satellite antenna; Check the signal strength in
LNB is set to "OFF" in the “Selective scanning” menu
LNB Setting menu
On-Screen Error Message Satellite not yet set Scan of in “Network scanning” or
“Channel data “Selective scanning” menu
does not exist.”
The device, packaging material (e.g. Styrofoam) and the batteries must never be disposed of with
household refuse. Please obtain appropriate information about the regulations in your community,
and dispose of all refuse in accordance with regulations at the separate locations provided.
DISPOSAL
TROUBLESHOOTING
MF68-00374A_GB 10/21/05 2:32 PM Page 26