Silvercrest BLUETOOTH KH 2376 - Instrukcja (Strona 15)

17
Installation
Bluetooth Car Radio KH 2376
GB
To avoid function disturbances the installation angle should be less than 30°. ■
Do not install the device in a location where it will be subjected to high ■
temperatures(i.e. direct sunlight or heating vents), heavy contamination and
strong vibrations.
In the event that changes to the vehicle are necessary contact your vehicle ■
dealer/qualifi ed radio installation facility.
Installing the device into the ISO duct
Pull the installation bracket ‹ 68 and the bezel frame 67 from the device's
housing.
Place the installation bracket into the ISO mounting duct. ‹
Bend the tabs on the installation bracket with a screw driver so that the bracket ‹
is fi xed fi rmly into the mounting duct (see diagram).
Check to make sure that the bracket is securely fi xed. ‹
Connect the ISO socket block of the device with the two ISO plugs on your ‹
vehicle.
Connect the antenna cable from the vehicle antenna to the antenna socket ‹
on the device.
Feed the microphone unit cable into the mounting duct and connect it to the ‹
microphone unit socket. Lay the cable in such a way that the microphone
unit can be secured later in the vehicle interior see chapter "Using the micro-
phone" on page 32.
Contingently connect the audio cinch cable of an external amplifi er to the ‹
LINE OUT sock et 39 on the device.
B_KH2376_33301_LB4A indb Abs3 17 17 07 2009 14 13 53 Uhr