Silvercrest SSR 10 A2 - Instrukcja (Strona 22)

SilverCrest SSR 10 A2
20 - English
 Briefly press the "PRESET" button (7). The display (1) indicates
"Alarm 1" (12), and when you briefly press the "PRESET"
button (7) again, the display (1) indicates "Alarm 2" (13).
 Select Alarm 1 or Alarm 2 and briefly press the "MODE"
button (3).
 The hour display flashes and you can then set it by pressing
the "-" button (2) or "+" button (4). Then press the "MODE"
button (3) again. The minute display then flashes and you can
set it by pressing the "-" button (2) or "+" button (4).
 Finally, press the "MODE" button (3) again. The display (1)
then indicates the current time and the alarm you just set is
active. This is indicated by the respective alarm symbol
(12,13) on the display (1).
Proceed in the same manner to set the second alarm.
Activating / deactivating the alarm function
When you have set the desired alarm time, you can activate the
alarm function as follows:
 Briefly press the "PRESET" button (7) repeatedly when the
device is switched off until the desired alarm symbol (12,13) is
indicated with the corresponding alarm time on the display (1).
 To deactivate the alarm function, briefly press the "PRESET"
button (7) until no alarm symbol (12,13) is indicated on the
display (1). The alarm function is then deactivated.
 The device wakes you at the set alarm time with a signal tone.
The alarm tone then sounds for approx. 60 seconds, followed
by a snooze period of approx. 60 seconds. On the display