Scarlett SC-157 - Instrukcja (Strona 5)

www.scarlett-europe.com SC-157 5
at the set level.
· If you want to change the room temperature, you can make another regulation: turn the
thermostat clockwise to arise the temperature and counterclockwise to lower it.
ATTENTION:
· Should the unit is overheat, provided safety device will switch it off automatically. In such
case switch the appliance off and unplug. Check all vents and try to restart again after at
least 5-10 minutes. If it not operates, connect a Service.
NOTE:
· The room must be sealed in good condition, if not, using of fan heater will not make good
result because of the influx of heat.
OSCILLATING MODE
· Your fan heater is equipped with 90
0 oscillating system.
· Set the oscillating base switch to the position to start oscillation.
· To stop the oscillation set the oscillating base switch to the position.
CARE AND CLEANING
· The convection heater should be cleaned regularly. As this may spoil the radiating efficiency.
· Always unplug the fan and allow it to cool down before cleaning.
· Wipe the outer surface of appliance with a soft damp cloth.
· From time to time clean the inside of the fan heater with vacuum cleaner, operating at low
setting.
· Do not use abrasive cleaners, gasoline, thinner or other chemicals to clean the fan.
STORAGE
· Complete all requirements of chapter CARE AND CLEANING
· It is recommended to keep the original box for after season storage.
· Keep the appliance in a cool, dry place.
RUS
·
.
·
.
· ,
, , .
·
. .
· .
· ,
.
· ,
. , ,
.
· .
· .
· .
· .
· .
· .
.
· , .
· ,
.
· .
.