Indesit IWDE-7105-B-(EU) - Instrukcja (Strona 7)

GB
7
Wash cycles and options
Wash options
- If the selected option is not compatible with the
programmed wash cycle, the indicator light will flash and
the option will not be activated.
- If the selected option is not compatible with another
option which has been selected previously, the indicator
light corresponding to the first option selected will flash and
only the second option will be activated; the indicator light
corresponding to the enabled option will remain lit.
Selecting this option enables you to suitably adjust drum
rotation, temperature and water to a reduced load of lightly
soiled cotton and synthetic fabrics (refer to the “Table of
wash cycles”). “
” enables you to wash in less time
thereby saving water and electricity. We suggest using a
liquid detergent suitably measured out to the load quantity.
Stain removal
This option is particularly useful for the removal of stubborn
stains. Place extra compartment 4 (supplied) into compartment
1.
When pouring in the bleach, be careful not to exceed the
“max” level marked on the central pivot (see figure).
To run the bleach cycle on its own, pour the bleach into extra
compartment 4, set the “Rinse” programme and activate
the “Stain removal” option.
Table of wash cycles
To bleach during a wash
cycle, pour in the detergent
and any fabric softener you
wish to use, set the desired
wash cycle and enable the
“Stain removal” option.
The use of extra compartment
4 excludes the “Pre-wash”
option.
Extra rinse
By selecting this option, the efficiency of the rinse is increased
and optimal detergent removal is guaranteed. It is particularly
useful for sensitive skin.
Delay start
To set a delayed start for the selected cycle, press the
corresponding button repeatedly until the required delay
period has been reached. When this option is enabled, the
corresponding indicator light will remain lit. To remove the
delayed start setting, press the button until the text “OFF”
appears on the display.
The information contained in the table is intended as a guide only.
For all Test Institutes:
1) Test wash cycle in compliance with regulation EN 50229: set wash cycle 2 with a temperature of 60°C.
2) Long wash cycle for cottons: set wash cycle 2 with a temperature of 40°C.
1 2
3
4
W
ash cycles
Description of the wash cycle
Max.
temp.
(°C)
Max.
speed
(rpm)
Drying
Detergents
Max.
load
(kg)
Cycle
duration
Prewash Wash
Ble-
ach
Fabric
softener
Daily
The duration of the wash cycles can be checked
on the display
.
1 Cotton with prewash: extremely soiled whites. 90° 1000    -  7
2 Cotton: extremely soiled whites. 90° 1000  -    7
2 Cotton (1): heavily soiled whites and resistant colours. 60° 1000  -    7
2 Cotton (2): lightly soiled whites and delicate colours. 40° 1000  -    7
3 Cotton: heavily soiled whites and resistant colours. 60° 1000  -    7
4 Coloured Cotton: lightly soiled whites and delicate colours. 40° 1000  -    7
5 Synthetics: lightly soiled resistant colours. 60° 800  -    3
Special
6 Wool: for wool, cashmere, etc. 40° 600 - -  -  1,5
7 Silk/Curtains: for garments in silk and viscose, lingerie. 30° 0 - -  -  1
8 Jeans 40° 800  -  -  3
9 Sport Light 30° 600 - -  -  3
10 Sport Shoes 30° 600 - -  - 
Max. 2
pairs
Drying
11 Cotton dry - -  - - - - 5
12 Synthetics dry - -  - - - - 3
13 Express Wash & Dry 30° 1000  -  -  0,5
Partial wash cycles
Rinse
- 1000  - -   7
Spin - 1000  - - - - 7
Drain - 0 - - - - - 7