Indesit DFP-58T1-EU - Instrukcja (Strona 11)

EN
11
Special wash cycles
and Options
Notes:
Optimum performance levels when using the “Rapid” and “Sixty”
cycles can be achieved by respecting the specified number of
place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
[email protected]
Wash options*
The OPTIONS may only be set, changed or reset after
the wash cycle has been selected and before the Start/
Pause button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
(see Table of wash cycles) , the
corresponding symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch
off, while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press
the corresponding button again.
Multi-functional tablets (Tabs)
This option optimises washing and drying results.
When using multi-functional tablets, press the MULTI-
FUNCTIONAL TABLETS button; the corresponding symbol
will light up. If the button is pressed again, the option will
be deselected.
The “Multi-functional tablets” option results in a
longer wash cycle.
The use of tablets is only recommended for models
having this option and it is not recommended with wash
cycles which do not specify the use of multi-functional
tablets.
Half Load
If there are not many dishes to be washed, a half
load cycle may be used in order to save water,
electricity and detergent.
Select the wash cycle and press the HALF LOAD button;
the indicator lights up.
Press the HALF LOAD button again to deselect this option.
The amount of detergent can be halved.
Delayed start
It is possible to delay the start time of the cycle by
a period of time between 1 and 24 hours:
1. Select the desired wash cycle and any other options
required; press the DELAYED START button. The indicator
light will go on. Use the same button to select when the wash
cycle will start (h01, h02 etc.)
2. Confirm the selection using the START/PAUSE button to
start the countdown.
3. Once this time has elapsed, the DELAYED START indicator
light goes off and the wash cycle begins.
To deselect the DELAYED START option, press the DELAYED
START button until the text OFF
appears.
The Delayed Start function cannot be set once a wash
cycle has started.
*
Only available in selected models.