MPM MUG-05 - Instrukcja (Strona 7)


GB
APPLIANCE DESCRIPTION
1. Hot air outlet
2. Handle
3. Power switch
4. Termostat knob
5. Timer
6. Air inlet
bEFORE YOU USE:
1. Please assemble the feet and the body in the order given in the picture below:
2. Place the convector on the flat desk or carton.
3. Insert the 2 position fins of the feet into the position holes of the body .
4. Tight the fixed screw to connect body .and feet.
HOW TO USE THE UNIT
It is normal for the heater to emit some odor when it is turned on for the first time, or after having not
been used for a long period of time. This will disappear when the heater has been on a short while.
1. Choose a suitable location for the heater, taking into account the safety instructions above.
2. Insert the plug of the heater into a suitable outlet,
3. Turn the thermostat knob fully in a clockwise direction to the maximum setting.
3. Turn on the heating elements by means of the rocker switches on the side of the heater. When
the heating elements are on, the switches will illuminate. one switch on, the heat output is 750W,
another switch on, the heat output is 1250W,For maximum heat output 2000W,both switches
should be on.fig.2
5. When the desired room temperature has been reached, the lights on the element switches are seen
to go out. After this, the heater will keep the air temperature in the room at the set temperature
by switching on and off automatically.
6. In its minimum (fully counter-clockwise) position. In this position (depending on the size of the
room) the heater will maintain the temperature above freezing.
7. You may also set the heater on and off automatically as you want a program in 24 hours by the
timer built-in the heater
1
2
3
4
5
6