MPM MUG-06 - Instrukcja (Strona 9)

9
GB
INSTALLATION FOR WALL MOUNTED
WARNING: Heater should be located on the wall where no combustible material is above the hea-
ter, and other sides of the heater should be at least 3 feet (0.9m) away from the nearby combustible
material.
Before using the heater as a wall mounted type, install it on the wall first, here are the steps for
the installation:
1. When mounted, enough space must be left around the heater. see fig.2
2. draw two horizontal lines on the wall, the distance between the two lines is 335mm, then drill
two holes at each horizontal line, be sure to make four holes diameter just as the same as that of
the plastic expanded pin(included separately in the plastic bag in the gift box),and the depth of
the holes just as the length of the plastic expanded pin, two holes distance at the upper horizontal
line should be 400 mm as the same as that of the slots on the back of the heater. Other two holes
distance at the lower line should be 396mm. see fig.3
3. Insert the plastic expanded pin into the four holes on the wall. See fig.4 4-4. Fix two screws to the
upper expanded pin, Keep the tips of the screws out for 8mm. See fig. 4
4. Fix two screws to the upper expanded pin, Keep the tips of the screws out for 8mm. See fig. 4
5. Install two spacers in the bottom of the heater. Fig 5
6. Put the two hooks through the tip of the screw on the wall, and slide into the slot , then drive the
screws tightly to the hooks. fig.6
7. Hang up the heater on the wall with its two slots getting into the hooks. Then tighten two spacers
at bottom of the heater to wall with two screws. fig.7
FIG.2 FIG.3
FIG.4 FIG.5
FIG.6 FIG.7