Media-Tech 3G HSDPA MODEM USB - Instrukcja

3G HSDPA USB MODEM
Instructions Manual High Speed Wireless Conectivity
MT4210
EN
Introduction
Thank you for your purchasing our HSDPA USB mo-
dem. Modem has driver stored on built-in memory.
Please take a moment and read this manual carefully
before using the device.
Installation
Note! It is strongly recommended to disable antivi-
rus/firewall software before installation procedure.
Please start your computer, and then connect modem
to USB port.
1) System at first will detect new storage device.
2) New storage device is ready to work.
7) Every time you plug modem - manager software will
start automatically. If it does not, click icon on desk-
top to run software manually.
5) Now wait 1-3 minutes, system will add modem to
system devices and appropriate modem manager
software.
3) If you have autoplay function enabled modem
driver installation will start automatically, follow on-
screen messages to finish process.
If modem driver instal-
lation does not start
automatically open “My
Computer” right click
“WCDMA USB Modem”
CD-ROM and select “Au-
toPlay”.
4) Click “Finish” when prompted.
6) On desktop following icon will be
shown.
Specification and appearance of product are subject to change without prior
notice. For technical support please visit www.media-tech.eu.
Troubleshooting
Driver or application software installation failed
Ensure at least 50MB of hard free disk space. Before installing the driver,
close all other programs including antivirus software.
LED indicator light, not flashing
Check SIM card, make sure it is installed properly.
If the indicator light is still not flashing, disconnect from USB port and
re-insert SIM card, and re-connect.
Modem manager can not start
HSDPA USB Modem connect to the PC, please wait about 5 seconds and
then run an application. The application will automatically test the equip-
ment connected or not and the SIM card inserted correctly or not.
Problem with installation under 64bit operating systems.
Before installation disable user access control in windows control panel.
Click „File/Settings/New”, enter parameters as shown
below (screen is for reference only). Click „OK.
T-flash card reader function
Under SIM slot there is a T-flash card slot, put there
your card. When modem is plugged into USB you can
access your T-flash card
When you are connected you can use default audio
input/output device as headset and make voice calls,
you only need to dial number and press green button.
You may also receive voice calls, internet connection
will be still provided during voice call.
Now select profile from drop down list and press „Connect”.
Voice call function