Media-Tech JUDGE RF - Instrukcja

Installing with Sony Playstation®
¯ Make sure that gamepad is fully charged.
¯ Plug USB receiver RF to USB port. Green LED will
fl ash (recesiver is searching for gamepad).
¯ Press HOME button on gamepad. Green LED will
be constantly on (receiver has found gamepad,
active connection channel LED will be on).
Installing with PC computer
¯ Insert driver CD into CD-ROM drive. If autorun
function is disabled open root folder CD and run
“setup.exe”.
¯ Follow on-screen messages to fi nish software in-
stallation.
¯ Now plug USB receiver RF to USB port.
¯ Windows “New Hardware Wizard” will recognize
and install new device automatically.
¯ Press HOME button on gamepad. Green LED will
be constantly on (receiver has found gamepad,
active connection channel LED will be on).
¯ You can check operating using Windows Control
Panel/Game control.
Charging
Use attached USB cable and connect gamepad to
PC computer, Sony Playstation® or other +5V USB
power supply. During charging channel LED indica-
tor will fl ash. After about 3 hours gamepad should
be fully charged.
Note! Fully charge gamepad before fi rst use.
Note! You can normally play when gamepad is
charged.
Reset
If you fi nd any strange behavior or gamepad
stopped responding you may try to reset the de-
vice. Use straightened paper clip and insert it into
RESET hole at the bottom of the gamepad.
Introduction
Thank you for choosing the MT1505 Judge RF
gamepad. You can use it with Sony Playstation 3®
or PC computer. Enjoy analog triggers and built-in
vibration motors. Please read this manual before
using the device.
Package Contents
¯ Gamepad ¯ USB receiver RF ¯ USB cable
¯ Driver CD for PC ¯ User’s manual
Overview
EN
JUDGE RF
User’s Guide Wireless Gamepad
MT1505
USB
Port Channel
LED
Reset
Home
button
USB receiver RF
Action buttons 8-way trigger
Analog triggers