Velleman WS8005 - Instrukcja (Strona 3)

WS8005
18.03.2010 ©Velleman nv 3
Setting the daily alarms
To view the set alarm times, under the clock mode, press once ALARM button, LCD displays the “”
icon.
` Press and hold down the ALARM button for 2 seconds until Alarm Time flashing icon is displayed. Now
use the “▲” and “▼“ buttons to select the alarm time you require and briefly press the ALARM button
to set this Alarm time.
` The Hour display of the Alarm time starts to flash. Use the “▲” and “▼“buttons to set the required
hour. Press ALARM button to confirm your setting
` The Minute display of the Alarm time starts to flash. Use the “▲” and “▼“buttons to set the required
minute. Press ALARM button to confirm your setting and to end the setting procedure.
` To activate or deactivate the daily alarms, briefly press the “ALARM” button once.
Info:
` After 30 seconds without pressing any button the clock switches automatically from setting mode to
Normal clock mode.
` The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In this case the
alarm will be repeated automatically after 24 hours.
` Rising alarm sound changes the frequency 4 times while the alarm signal is heard.
Automatic Snooze function
` Proceed as follows to activate the automatic Snooze function: While the alarm is sounding, press the
SNOOZE button to activate snooze function. Then Snooze function is active. The “” icon appears on
the display.
` This operation moves the alarm back by 5 minutes and the alarm will restart at this time.
` The Snooze function can be interrupted by pressing any button.
°C/°F temperature display:
` The temperature is displayed either in °C or °F. Briefly pressing the “▼ “button allows you to switch
between the individual models.
Reception of the Radio signal
` The clock automatically starts the DCF signal search after 7 minutes of any restart or changing of new
fresh batteries. The radio mast icon starts to flash.
` At 1:00 am, the clock automatically carries out the synchronization procedure with the DCF signal to
correct any deviations to the exact time. If this synchronization attempt is unsuccessful (the radio mast
icon disappears from the display), the system will automatically attempt another synchronization at the
next full one hour. This procedure is repeated automatically up to total 5 times.
` To start manual DCF signal reception, press the “WAVE“ button. If no signals received within 7
minutes, then the DCF signal search stops (the radio mast icon disappears) and start again at the next
full one hour.
` During RC reception ，to stop searching radio signal, press the “WAVE“ button once.
Info:
` A flashing radio mast icon indicates that the DCF signal reception has started
` A continuously displayed radio mast icon indicates that the DCF signal was received successfully
` We recommend a minimum distance of 2.5 meters to all sources of interference, such as televisions or
computer monitors
` Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In such extreme
circumstances, place the system close to the window.
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.